Special Notice from Veterans Affairs, Department of, solicitation 36C24127Q0079. Responses due Nov 25, 2026. NAICS 238220. Listed on SAM.gov.
The Department of Veterans Affairs, Networking Contracting Office (NCO 01) located in Brockton, MA intends to enter into a sole source procurement, pursuant to the authority of FAR 6.302-1, with TRANE U.S. Inc., for the following requirement: STATEMENT OF WORK SCOPE OF WORK The Contractor shall provide all supervision, personnel, material, parts, equipment, supplies, labor and transportation in performing basic intelligent services on the Trane Building Control Units located at the Department of Veterans Affairs Medical Center, 1400 VFW Parkway, West Roxbury, MA 02132 in accordance with all terms and conditions of this contract. Period of Performance: one base year plus two option years. DEFINITIONS/ACRONYMS A. Contract Discrepancy Report (CDR) : A report that the Government shall complete and issue to the Contractor when service is unsatisfactory and not in compliance with the terms and conditions of the contract. The Contractor is required to complete and return this form to the COR whenever performance is unsatisfactory. The CDR requires the Contractor to explain, in writing, the cause of the unsatisfactory performance, how performance will be returned to acceptable standards, and how reoccurrence of the problem will be prevented in the future. B. Contracting Officer (CO) : The individual with the authority to enter into, administer, and/or terminate contracts. The CO is the exclusive Government official authorized to execute changes and deviations or variations in the contract. C. Contracting Officer's Technical Representative (COTR) : A Government representative, designated in writing by the Contracting Officer, to be responsible for quality assurance, inspection, surveillance, documentation and acceptance of the Contractor's performance. A copy of the letter of designation will be provided to the Contractor. D. Preventive Maintenance (PM) : Services which are periodic in nature and are required to maintain the equipment in such condition that it may be operated in accordance with its intended design and functional capacity with minimal incidence of malfunction or inoperative conditions. To clean, lubricate, calibrate, test and replace faulty or worn parts and/or parts which are likely to become faulty, fail or become worn, repair or adjust components, or assemblies of components as necessitated by wear, tear, damage, or failure of parts, returning the equipment and/or instrument to the operating condition defined in the manufacturer s specifications. E. Repair Cost Estimate: The Contractors estimated cost (for parts, labor and freight ) to repair a system according to manufactures' specifications and requirements. F. Time: When hours are given it shall mean clock hours exclusive of Saturdays, Sundays and Holidays unless otherwise specified (i.e., 1:00 P.M. Monday to 1:00 P.M. Tuesday equals 24 hours; 12:00 P.M. Friday to 12:00 P.M. Monday equals 24 hours). If days are indicated it shall mean calendar days including Saturdays, Sundays and Holidays. G.Rework. Any work the Contractor is required to accomplish due to unsatisfactory performance or nonperformance in accordance with the stated quality and level of effort specified in the contract. Rework is performed at no additional cost to the Government. H. ESR. Vendor Engineering Service Report. A documentation of services rendered for each incidence of work performance under the terms and conditions of the contract. I. Acronyms. Commonly used acronyms are listed below FSE: Field Service Engineer AQL: Acceptable Quality Level IAW: In Accordance With QA: Quality Assurance QC: Quality Control WS: Performance Work Statement VA: VA Medical Center CO: Contracting Officer COTR: Contracting Officer s Technical Representative FES: Facilities and Engineering Service PREVENTIVE MAINTENANCE REQUIREMENTS Within 14 calendar days of Notice to Proceed, the vendor will submit to the COTR a written schedule of the planned PM visits for the coming year along with a written description of the work to be performed during each visit. Refer to paragraph IV.B. below for schedule and inspection requirements. Each inspection will be provided in accordance with the system/equipment manufacturers factory recommended procedures. Each inspection shall, at a minimum, include the following as specified for the equipment make, type, and time of seasonal operation. Any additional parts not identified in this document will not be covered by this contract. The vendor will obtain prior approval from the COTR prior to performing any additional repair work and the additional work will be billed separately. For each PM inspection, the contractor will provide a detailed written report to the COTR that summarizes work performed, problems/deficiencies found, and measurements taken. This report will be submitted within 10 calendar days of the date of PM inspection. All work will be performed between the hours of 7:30 a.m. and 4:00 p.m. on the prearranged dates. The contractor shall perform preventive maintenance and technical support services on the equipment identified in the contract's covered equipment schedule in accordance with manufacturer-recommended procedures and the service activities specifically identified in the Statement of Work. Within 14 calendar days of Notice to Proceed, the contractor shall submit a proposed annual maintenance schedule identifying the covered equipment, planned service activities, service frequency, and anticipated dates of performance. The minimum required service frequencies and quantities shall be established in the contract prior to award. Upon completion of each scheduled maintenance activity, the contractor shall provide a written service report documenting the equipment serviced, inspections and tests performed, software or programming adjustments completed, deficiencies identified, and recommendations for corrective action. …